How to Record the Condition of Card Holders and Outer Packaging Before Shipping
Before shipping, first establish a traceable record for the card holder and outer packaging: numbering, six-sided photos, weighing, sealing and handover times, so that the condition before and after transport can be compared item by item.
On this page
The Purpose of Recording: Making the Condition at Dispatch Comparable
The core of a shipping dispute is often not the card itself, but the inability to state clearly "what it looked like when it was sent." Recording the card holder and outer packaging establishes a comparable baseline for the moment of dispatch: whether the holder has scratches, cracks or lifted label edges, and whether the outer packaging has dents, unglued seams or traces of secondary tape, are all fixed before the item leaves your hands.
Recording is not a condition grade for the card, nor does it replace inspection. It only answers the question of the transport stage: whether the condition on arrival matches the condition at dispatch. The record must therefore be reviewable by a third party—with a number, a time and identifiable details, rather than a few photos taken at random angles.
Continuous Recording Steps from Cleaning the Surface to Sealing the Box
- Number first, then start: Write a unique number on the card holder and on the outer packaging, on the record sheet and on the outer packaging in a place that does not touch the card face; all subsequent photos must include the number.
- Photograph six sides of the card holder: One each of the front, back and four edges, plus one oblique side-light photo so that scratches and cracks show up under side lighting.
- Photograph the original state of the outer packaging: Before sealing, photograph the six sides of the box, the seams and the tape positions, focusing on existing dents, unglued areas or old tape residue.
- Weigh and record: Weigh once before and once after sealing the box, and write the numbers on the record sheet as a supplementary reference for packaging integrity.
- Seal and photograph the seal close-up: Apply tape across the seam and photograph the tape direction and overlap position, so it can be checked on arrival for signs of reopening.
- Record the handover time: Write down the dispatch date, carrier method and tracking number, and keep them in the same archive as the photos.
Card Holder Records and Outer Packaging Records: The Focus Differs
Both must be photographed, but the focus differs. Card holder records lean toward the integrity of the card's protective layer, while outer packaging records lean toward whether the transport process was interfered with.
Card holder** Focus on scratches, cracks, lifted label edges and whether the card is loose inside the holder; photos are mainly close-up side lighting.
Outer packaging** Focus on box dents, seam ungluing, tape position and resealing traces; photos are mainly overall shots plus seal close-ups.
If the card holder already has old marks, photograph them clearly before shipping; otherwise it will be hard to distinguish original marks from new transport damage on arrival. For outer packaging, keep two sets of photos—"unsealed" and "sealed"—to form a before-and-after comparison.
Which Fields a Record Sheet Should Contain
| Record item | Content recorded | Purpose |
|---|---|---|
| Number | Card holder number, outer packaging number | Match photos to the physical item |
| Card holder condition | Scratches, cracks, label, looseness | Distinguish original from new |
| Outer packaging condition | Dents, ungluing, tape position | Determine whether it was resealed |
| Weight | Before sealing, after sealing | Supplementary integrity check |
| Time | Photographing, sealing, dispatch | Establish the time sequence |
The table need not be complex; the key is that every item can be matched to a corresponding image in the photos. When fields are missing, the value of later supplementary notes drops noticeably.
Photographing Only the Card Front Does Not Show the Condition at Dispatch
Common myth
One clear photo of the card front is enough to prove the condition at dispatch.
Physical reality
A front photo cannot show the card holder edges, the back or the outer packaging seal, and shipping disputes often arise at these locations.
A card front photo answers "what the card looks like," while a shipping record must answer "whether the protective layer and packaging were intact when they left your hands." The two cannot substitute for each other. Chips on the holder corners, lifted label edges and unglued box seams are only clearly visible at specific angles and under specific lighting.
The Most Error-Prone Points in the Recording Process
Photos without numbers cannot be matched to the physical item when multiple items are shipped; remembering to photograph the original state only after sealing means the comparison is already lost; shooting with strong reflective front lighting hides scratches under glare; weighing only once makes it impossible to tell whether items were added or removed midway; storing the record sheet and photos separately makes it hard to piece them together later. These oversights do not cause immediate loss, but they make it difficult to provide evidence when a dispute arises.
Common Questions About Shipping Records
The card holder already has scratches—should I still photograph them?
Yes. Existing marks are exactly what needs to be fixed in the record; photographing them clearly is how you distinguish old from new on arrival.
Can I photograph the original state of the outer packaging after sealing it?
It cannot be restored. Only photos taken before sealing show the original state; after sealing you can only record the sealing result.
How long should the record be kept?
At least until the other party confirms receipt and the condition check is complete; do not overwrite or delete the original images during that period.

